Large format porcelain on CNC bridge saws demands chip-free sintered blades with correct bond and RPM settings.
Fabricators cutting 12mm and thicker large format porcelain on CNC bridge saws face chipping, edge blowout, and premature segment wear when blade selection is wrong. Protec Tools sintered diamond blades are engineered for controlled kerf and clean edges on hard ceramic surfaces.
Blade Selection
- Sintered segments for stable cutting on ultra-hard porcelain.
- Continuous or fine turbo rim to reduce edge chipping.
- Medium to hard bond matched to porcelain hardness and feed rate.
CNC Setup Checklist
- Verify blade diameter and arbor match bridge saw specification.
- Run wet with adequate flow at the kerf contact point.
- Set feed rate conservatively on first pass to validate edge quality.
- Inspect segment wear after each slab batch.
Protec Tools supports stone fabricators with bridge saw blades in common diameters for European and Asian CNC equipment.
Related Protec Tools products: Laser welded diamond blade, Sintered diamond blade, Diamond core drill bit, Diamond grinding wheel
