High production standard diamond saw blades and diamond saw blades prepared by research institutes have the advantages of durability, high cutting efficiency, and long service life.
The matrix of diamond saw blades has large deformation, inconsistent thickness, and large inner hole tolerance. When there are congenital defects in the above-mentioned matrix, regardless of the type of equipment used, there are grinding errors. The tolerance of the outer circle of the substrate is large, while the tolerance of the outer diameter of the substrate is large.
During assembly, it is prohibited to look at the diamond saw blade in the direction of high-speed rotating products to avoid personal injury or death accidents.
Poor straightness can lead to cracking and burrs at the orifice, difficulty in removing a pile lump, unstable joint quality, and excessive gap in the use of the joint.
Correctly and reasonably determine the drilling speed, whether the speed is based on the standards of slipping and motor damage, and the error caused by slipping and motor damage.
When the hydraulic control system is activated, the CNC lathe monitors the operating error and rebound force of the shaft in real time, and monitors whether the tool holder position is inserted and reset in real time.
● Hydraulic transmission system abnormal alarm, check whether the air pressure is normal, check whether the hydraulic system is normal, and based on feedback, make control to make the hydraulic components run according to the installation coordinate axis, and confirm whether the lubricating oil meets the requirements.
There are cutting heads and drilling tools on the protective cover of the end milling machine tool to confirm whether they can cut edges and ensure the dimensional accuracy of milling processing.
The flushing fluid of the X-axis should be injected into the outside of the large water pump, and the drill bit and drill pipe should not be easily placed smoothly to avoid causing downhole accidents.
The base of the drilling machine should be reliably grounded and able to obtain resistance at the top diameter level in a timely manner. The top diameter of the base should not be less than 1/3 of the pipe diameter.
The positioning requirements of the CNC bending machine mold should comply with the drawing requirements, and after completion, a detailed inspection should be conducted for any damage.
Tightly surround the left side of the chip removal groove, then extend the top rod slightly higher than the plate diameter, and then tighten the bending rod. During drilling, adjust and quickly until the requirements for concentric circles and tapers are met.
After the roller is installed into the pin hole, it is necessary to remove the roller. The aluminum inside the outer tube of the roller and the radial gap between the outer roller and the pin hole should meet the requirements of the drawing to ensure that the roller is sharp.
