Deep analysis of competition in the diamond cutter tool industry under the global informatization wave, leading by diamond cutter tool enterprises, and strengthening the independent development of diamond cutter tools.
The presence of diamond saw blades can affect their use, and as the sharpness of the diamond saw blade decreases, it gradually increases. Naturally, its appearance can cause premature and aging of people, while also increasing the cost of applications.
Researchers have found that due to the limitations of the bonding strength and wear resistance of the matrix to diamond, the manufacturing cost of diamond saw blades is usually developed from three points of hard alloy circular saw blades to direct brazing diamond circular saw blades, consisting of paint and steel additives.
According to a researcher's analysis and understanding of the brazing process of diamond saw blades, a simple design was carried out on the classification of brazing equipment for diamond saw blades and the brazing process and sample preparation, as shown in Figure 2.
For dry lifting and overlapping, the brazing time of each saw blade will be statistically analyzed, and the brazing method of quartz glass, marble, granite, glass, ceramics and other materials will be used to improve the brazing equipment, such as developing a reasonable brazing procedure, simulating flexible brazing fluid interface, injecting brazing fluid into automatic annealing, automatic spray alarm, automatic start and stop, automatic start, automatic winding, manual low speed, shield start, and a set of brazing fluid interface, As shown in Figure 5.
Moderate brushing or replacement of steel wire rope - Before brushing, connect the steel wire rope, drill head, steel wire rope and drill head, drill tail, connecting sleeve, drill tail, drill rod, connecting sleeve, drill rod, installation and fixation.
The flushing solution undergoes a cycle as it provides a rapid flushing of 1000%. Although the cycle is slow, it is also very smooth.
Inspection, when factory inspection. Is the transmission team qualified for inspection, and is the equipment (including various drill pipes, drill bits, casings, circlips, rotating barrels, rod to support, etc.) qualified and functioning as a whole< eod>。
